Setup guide

Index–1
Index
Numbers
0% Ribbon life, 6–12
48 Volt Failed message, 5–17
80–9F Hex parameter, 3–38
A
ACK/NAK serial protocol, 4–11
Acoustic noise levels, A–4
Address Error message, 5–17
Alarm On Fault parameter, 3–37
Alarm, paper jam, enabling, 3–47
Alignment, vertical, improper, 5–7
Alternate terminating resistors, 4–9
Analyze Job parameter, 3–27
Analyze mode (RibbonMinder)
analyzing jobs, 6–14
setting, 6–15
shortcut, 6–17
Application Compatibility menu, 3–32
ASCII character set, C–1
Asterisk (*) in fault messages, 5–16
Auto Line Feed parameter, 3–44
B
Back space, control code 08, 3–39
Bar codes, creating. See IGP (Intelligent
Graphics Processor)
Bit 8 Function parameter, 3–59
Buffer Size parameter, 3–34
Bus Error message, 5–17
C
Cable connections, 2–12
Carriage return control code, 3–44
Case, upper/lower, 3–35
Centronics menu, 3–50
Centronics parallel interface, 4–6
configuration, 4–8
signals, 4–7
Chains, paper, unpacking, 2–10
Change Ribbon message, 5–17
Changing parameters, unlocking the menu,
3–7
Character
attributes, supported, 1–6
formation, B–2
Character sets, 3–30
ASCII, extended. See Bit 8 Function
parameter
U.S. ASCII, C–1
Cleaning requirements, 5–2
Coaxial/twinaxial interface, 1–7, 4–2
Commands, RibbonMinder, 6–21
Compress Print parameter, 3–40
CONFIG key, loading configurations, 3–21
Configuration, 3–4
Centronics parallel interface, 4–8
changing values, 3–13
factory values, 3–9
IBM 3287 values, D–5
IBM 5225 values, D–5
IGP values, D–4
loading customized configurations, 3–21
loading factory configurations, 3–18
menu, 3–5