Setup guide

D–5Predefined Configuration Values
Table D–3. IBM 3287 and 5225 Configuration Values
Configuration
Parameter
Factory Default
Value
Configuration
Parameter
Factory Default
Value
Ribbon Life Paper Format
Job Rate Currently 150 Line Spacing Set at 6 LPI
Ribbon Size Currently 60 Form Length Set At 1 1 Inches
When W orn Action To Stop Printer Auto Line Feed Disable
Enable/Disable Disable Action Define CR Code CR = CR
Define LF Code LF = CR + LF
Font VFU Select EVFU
Font DP AT 10 CPI Perforation Skip Disable
Paper Out End of Paper
Character Set Paperout Adjust 1 13 Dot Rows
1
Select Set MULTINATIONAL PMD Fault Enable
Select Subset MULTINATIONAL Set Platen @ BOF Disable
Select Language ASCII Print Width 13.2 Inches
Slow Paper Slew Disable
Application Compatibility
Printer Protocol P-Series
Buffer Size 2048 Characters
Paper Advance SW Print + Pap Adv
Power On State On-Line
Alarm On Fault Enable Host Interface Centronics
Shuttle Timeout 4 Seconds Data Bit 8 Enable
Unidirectional Disable PI Line Disable (3287)
Enable (5225)
Select SFCC 01 SOH Data Polarity Standard
80–9F Hex. Printable Resp. Polarity Standard
Control Code 06 8.0 LPI Fast Busy Enable
Control Code 08 Double High Strobe Polarity Standard
Overstrike Enable Latch Data On Leading Edge
View Lines
Display Language English
Notes:
1. The paper out adjust value is not af fected by loading, saving, or clearing NVRAM. Its value may
only be explicitly changed in the menu.