Setup guide
6–19RibbonMinder
Step
Press Result Notes
1. Verify
that the job rate has been recorded in “Analyze Job” mode. Refer to the previous section,
“Analyzing Jobs.”
2.
ON LINE
Off–Line xxx%
Ready 1
The printer must be off-line to
change the configuration.
3. Raise the printer cover.
4.
+
ENTER Switch
Not Locked
Press
both keys at the same time.
Unlocking permits configuration
changes.
5.
Ribbon Life xxx%
6.
Ribbon Life xxx%
New Ribbon
7.
UNTIL
Ribbon Life xxx%
Set Job Rate
8.
Currently xxx
New Rate xxx *
Analyze Job
New Rate yyy
— OR —
(A)
(B)
If the printer is in “Analyze Job”
mode, message (A) appears.
If the printer is not in “Analyze
Job” mode, message (B)
appears.
9. If the printer is in “Analyze Job” mode, and if you want to enter the analyze mode rate as the job rate,
go to step 1
1. Otherwise, continue with step 10.