Setup guide

6–15RibbonMinder
Setting Analyze Job Mode
Step Press Result Notes
1.
ON LINE
Off–Line xxx%
Ready 1
The printer must be off-line to
change the configuration.
2. Raise the printer cover.
3.
+
ENTER Switch
Not Locked
Press both keys at the same time.
Unlocking permits configuration
changes.
4.
Ribbon Life xxx%
5.
Ribbon Life xxx%
New Ribbon
6.
UNTIL
Ribbon Life xxx%
Analyze Job
7.
ENTER
Ribbon Life 1000
Change Ribbon
Pressing ENTER sets the
“Analyze Job” mode. A message
to change the ribbon appears.
8. Verify that a new ribbon has been installed. Refer to the section “Setting Up a New Ribbon” on
page 6–6 if necessary .
9.
CLEAR
Off–Line xxx%
Ready 1
10. Close the printer cover.