Setup guide

6–7RibbonMinder
Step NotesResultPress
8. Remove the old ribbon and install a new one (see the Operator’ s Guide ). If you try to print before
changing the ribbon, the printer displays the fault message, “Fault Condition, Change Ribbon”.
9. To set or change the ribbon size, go to page 6–8, step 4. Otherwise, continue with this procedure to
exit.
10.
CLEAR
Off–Line xxx%
Ready 1
11.
+
ENTER Switch
Locked
Locking prevents settings from
being changed.
12. Close the printer cover.
13.
ON LINE
On–Line xxx%
(Current Font) 1
Places the printer on-line, ready
for normal operation.