Setup guide

5–8
Routine Service and Diagnostics
• Paperout Adjust
A pattern used to determine the number of dot rows from the completion
of a paper out fault to the end of the paper.
• Demo
A text and graphics pattern that illustrates many of the printer’s features.
This test can also be used to identify phasing problems within different
character pitches and font styles.
• Phase Adjustment
A timing test used by qualified service personnel to adjust vertical
alignment of dots in character printing.
IMPORTANT
The phase adjustment test should be performed only by qualified service
personnel. This test is a part of the hammer phasing adjustment
procedure. This adjustment procedure is described in the Maintenance
Manual; refer to it for details.
Configuration Printout
Pressing ENTER when this message is displayed prints the configuration.
The printout lists the printer’s configuration parameters that are currently in
use. For convenience, the printout lists the main menus and submenu
parameters in the same order as they occur when you use the control panel to
configure the printer.
While the configuration is printing, the message “Configuration Printing”
displays. You can wait for the printer to stop by itself or press ENTER again
to stop the printing. The display returns to the “Configuration Printout”
menu.
NOTE: Once you have determined the correct configuration, be sure to print
it and save it for future reference. Printing the configuration is also
recommended if you have changed any parameters.
For more information, see the section titled “Printing The Current
Configuration” on page 3–12.