Setup guide

Configuring the Printer3–64
Load Saved Parameters (1, 2, 3, or 4)
NOTE: Although you can use this menu to load customized configurations,
it is recommended you use the CONFIG key. See page 3–22.
Pressing ENTER when this message displays loads the first (or second, third,
or fourth) set of parameters you saved previously.
After you press ENTER, the message “Load Saved Completed” will display
for about one second. Then, the display returns to the “Load Saved
Parameters” menu.
Load IGP Parameters
Pressing ENTER when this message displays loads the permanently-stored
factory-set parameters for the IGP.
After you press ENTER, the message, “Load IGP Completed” will display.
for about one second. Then, the display returns to the “Load IGP Parameters”
menu.
Load IBM 3287 Parameters
Pressing ENTER when this message displays loads the permanently-stored
factory-set parameters for the IBM 3287.
After you press ENTER, the message, “Load IBM 3287 Completed” will
display for about one second. Then, the display returns to the “Load IBM
3287 Parameters” menu.
Load IBM 5225 Parameters
Pressing ENTER when this message displays loads the permanently-stored
factory-set parameters for the IBM 5225.
After you press ENTER, the message, “Load IBM 5225 Completed” will
display for about one second. Then, the display returns to the “Load IBM
5225 Parameters” menu.