Manual

Install the Ferrite
25
Figure 9. Position the Ferrite
15. On the electronics side of the printer, position the ferrite on top
of the upper DC motor. (
Figure 9.)
16. Route the power/data cable through the wire saddle as shown
in
Figure 9.
17. Plug the P10 connector end of the power/data cable into the
J10 receptacle on the controller board.
NOTE: For SL5000r/T5000r Energy Star models see Figure 10 on
page 26.
183461a
J10
Power/Data Cable
Ferrite
Upper
DC Motor
Wire Saddle