Manual

57
Main Menu
Brief descriptions follow for the first-level configuration menu options:
• QUICK SETUP — These options allow quick access to the most
frequently changed or inputted parameters during the installation of the
printer.
• ZTP SETTINGS These options allow you to set parameters for zero tear
pedestal printers.
• CONFIG. CONTROL — These options allow you to save, print, load,
delete, name, and reset entire sets of configuration parameters.
• HOST INTERFACE — These options allow you to select either the Serial
RS-232, Serial RS-422, Centronics
®
parallel, Dataproducts
®
parallel and
Long Lines, Ethernet
™
, IEEE
®
1284 parallel, or Auto Switching for the
printer. This menu also allows you to configure several parameters for
each interface.
• NETWORK SETUP — This option allows you to select from Ethernet
Address options and Ethernet Parameters options.
• ACTIVE (IGP) EMUL — This menu allows you to select the PGL or VGL
emulation from the menu if IGP is installed.
• EMULATION — This menu allows you to configure the options which are
available for the current operating (active) emulation. For example, if
LinePrinter+ is the active emulation, then the LinePrinter+ emulation
options can be configured using this menu.
• PRINTER CONTROL — This menu allows you to select parameters
common to a general user, such as display language and Barcode
quality.
• ADVANCED USER — This menu allows you to select several advanced
operating parameters for the printer, such as the speed at which paper
will advance when slewing.
• DIAGNOSTICS — This menu includes the diagnostic tests, system
memory, software build part number, Feature File (if one exists),
the shuttle type, and statistics of the printer.
• PRINTER MGMT – These options allow you to select the PNE port type,
port number, port timeout period, status port number, and management
port number.