Manual

N7000 STD ASCII Printers Fault Messages
205
WELD RESET ERROR
See User Manual
No The cartridge weld
circuitry lost power.
Contact your authorized service
representative.
1
WELD SNSR MISSING
See User Manual
Yes Weld sensor cannot be
detected by the system.
1. Make sure that weld sensor is
installed correctly.
2. Contact your authorized
service representative.
1
1
Before contacting an authorized service representative, power off the printer, wait 15 seconds, then
power it back on and rerun your print job. If the message reappears, press CLEAR. If the fault message still
displays, then contact your authorized service representative.
Table 12. N7000 STD ASCII LCD Fault Messages Troubleshooting
Displayed Message
Can User
Correct?
Explanation Solution