User`s manual

Chapter 6 System Status And Error Messages
226
Procedure For Fault Clearing - Reprint On Fault Enabled
1. A fault occurs.
2. Correct the fault condition.
3. Press CLEAR.
4. The STAND BY LED blinks and the following message appears
while the printer attempts to clear fault:
• If the fault is not cleared:
a. The printer beeps and briefly displays the following
message:
b. The printer then redisplays the original fault message, or
any other uncleared fault message.
c. Attempt to clear the fault condition again, or contact your
service representative.
• If the fault is cleared, and if you do not need to reload the paper
into the tractors (for example, the printer ran out of toner):
a. The printer goes OFFLINE.
b. Press ONLINE to resume printing.
• If the fault is cleared, and if you need to reload paper into
the tractors (such as after a paper jam), the following message
appears:
a. Reload the paper onto the tractors.
Clear Paper Path
for Reprint
Standby ...
Clearing Fault
Faults Not Cleared