User`s manual

Chapter 3 Loading Flash Memory
122
42. Make the diskette drive the active drive by typing the following
at the DOS prompt:
A: <Return>
(If the diskette is in drive B, type B: <Return>)
43. Get the names of all of the logo, form, TIFF, setup, and font
files that you want to download by listing the contents of the
directory; at the DOS prompt type:
DIR <Return>
The downloadable files in the directory take the form
file_name .dwn
Write down the complete name of each file with the .dwn
extension.
44. Download the files to the printer by using the DOS copy
command. Enter the following at the DOS prompt, for example:
copy /b file_name1.dwn+file_name2.dwn+... LPT1 <Return>
NOTE: The above command example assumes that LPT1 is used
as the download port from the computer, and that the
printer is already in download mode, waiting for file
download, before you copy the files to the printer. If you are
downloading the files using the LPT2 port on the computer,
substitute “LPT2” for “LPT1” in the above commands.
45. While the files are being copied into memory, the printer LCD
informs you of the load process and status. (Messages are
listed in the table on page 228.)
46. Wait until the new files have successfully loaded into printer
memory.
47. If you have any more software to install (logo, form, TIFF,
setup, or font files), go back to step 37.
48. When all of the new software has successfully loaded into
memory and the printer has reset itself, set the printer power
switch to O (off).