User`s manual

Chapter 3 Paper Control Menu
100
When Burst on Eject is disabled, note the following effects:
• PAGE EJECT: When you press PAGE EJECT or send a
~PAGE EJECT command, the paper is not separated and is
not rolled back into the printer. Instead, enough forms are
inserted to fuse and move all pages physically out of the
printer. The exact distance depends on the current Paper
Length selection. The paper moves a minimum of 25.5 inches.
Note that the printer uses Paper Length and not Form Length
for paper motion. If the current Form Length is not a multiple of
1/6 inch, the exact distance the paper is moved is not a multiple
of the form size. When using a preprinted roll-feed form, the
physical top-of-form may be lost.
• FORM SIZE CHANGE: A form size change operates the same
as pressing the PAGE EJECT key. Instead of separating the
form, enough form feeds are inserted to move the printed
pages out of the printer.
No Back Feed
No Back Feed automatically disables (default) or enables back
feeds.
Cutsheet Options
Cut Sheet Output
Cut Sheet Output specifies which output tray is used. You may
select the face down (default) or face up orientation. The face down
tray is located on the top of the printer, the face up tray is located
above the optional power stacker.
NOTE: If you select the face up tray, the first page printed is on the
bottom of the stack, and the last page printed is on the top
of the stack.
The Cut Sheet Output menu option is used only if the printer has
the cut sheet paper feed option installed.