User`s manual

Chapter 2

Configuration Tools

If the Netmask does not match, complete the following steps:

a. Place the printer offline.

b. Using the front panel, modify the Gateway value to 0.0.0.0.

(non-configured).

c. Place the printer online and wait for the “E-NET READY”

message to display.

d. Place the printer offline and enter the Gateway Address

you desire.

e. Place the printer online and wait for the “E-NET READY”

message. This saves the new Gateway Address.

Your NIC is now configured and connected to your network.

Wireless NIC Configuration Using

The Control Panel

NOTE: The Access Point must be configured according to the

manufacturer's installation guide.

To configure Wireless NIC card, configure the ethernet and

wireless IP addresses so they can be seen on the network. This

includes several network-related settings (e.g., an IP address within

TCP/IP environments) configured through the built-in command

shell, npsh, or from the control panel.

Wireless Parameter Configuration

Certain "WIRELESS PARAMS" must be configured to match the

Access Point settings:

•

Signal Strength

This menu displays the strength of the wireless signal.

NOTE: This is a display value only and cannot be changed.