User`s manual

Configuration Using The Control Panel

You can set NIC settings from the printer control panel.

CAUTION

When the printer is first powered on, E-NET INIT. displays on

the control panel. To prevent a loss of NIC configuration

information, do not change the NIC settings while this

message displays. When the initialization is complete, E-NET

READY displays and you can safely change the NIC settings

from the control panel.

1. You can set any of three listed parameters from the printer

control panel. These parameters are located in the Ethernet

Address or Wireless Address menu.

2. Power on the printer. E-NET INIT. displays when the printer is

powered on. Configuration can be done after E-NET READY

displays.

3. Verify the current NIC firmware version number.

The NIC version should be 1.1.3 or higher for 10/100Base-T

Ethernet adapters. If the NIC version is current, skip to step

below. If the NIC version is not current, you need to update

both the NIC and printer firmware.

4. From the front panel, navigate to the IP Address, Netmask, and

Gateway Address (Subnet Mask) menu options and enter the

appropriate values. You must press ENTER after inputting

each segment of the IP Address, Netmask, and Gateway

Address.

5. Put the printer online and wait for the “E-NET READY”

message to display on the front panel. Placing the printer

online starts the NIC IP Address and Netmask update process.

This process will take several minutes.

NOTE: If you do not put the printer online, the setting you just

entered will not take effect. Do not turn the printer off until

you see the “E-NET READY” message. If you turn the

printer off before the new values are written to memory in

the NIC adapter, you will need to repower the printer and

repeat steps

4 and 5 above immediately.