User`s manual

NetWare Version 4.x and 5.x PSERVER Setup
149
8. Select Print Servers.
9. Click Insert to add the new print server.
10. Type the name of the NIC. The default is M_xxxxxx or
M302_xxxxx for the Wireless Adapter where, xxxxxx
represents the last six digits of the NIC address found on the
configuration printout or control panel settings under Ethernet
Parameters, MAC address (e.g., M_091C1A or M302_00008).
11. Select this new print server and press ENTER.
12. Select Printers.
13. Click Insert to add a printer to the list.
14. Type in the name of one of the default destinations on the unit
for the Name field, and go to the Type field.
15. Press ENTER at this field and select Defined Elsewhere. If
Defined Elsewhere is not available, choose Parallel.
16. Press ENTER on the Print Queues Assigned field.
17. Click Insert to display all queues; select the one you defined in
step 5 and press ENTER.
18. Select a priority and press ENTER. Priority 1 should be
sufficient.
19. Press Escape until you are back to Main Menu.
20. Reboot the Print Server by repowering the printer.
21. Check the Currently Attached Servers and verify the print
server is active.
22. Press Escape until you are out of the PCONSOLE.
Even though the entire print set up is done through PCONSOLE,
you may want to communicate directly with the print server in order
to modify settings, monitor the unit, etc. To communicate with the
print server, the optional host software, npsh.exe, is included.
npsh.exe is a DOS executable program that can be run from a
DOS prompt on a NetWare workstation.
npsh.exe performs the following: