User's Manual

Chapter 2 QUICK SETUP Menu
42
remind you to remove the label before the next one can be
printed.
• Cut. When the optional media cutter is installed, it
automatically cuts media after each label is printed or can cut
after a specified number of labels have been printed using a
software cut command. It cuts continuous roll paper, labels, or
tag stock.
NOTE: This option is hidden when RFID Reader is set to Enable in
the RFID CONTROL menu.
• Continuous. Printer prints on the media and sends it out the
front.
The default is Tear-Off Strip.
Paper Feed Shift
This menu item represents the distance to advance a label (+ shift)
or pull back (– shift) when the Tear-Off Strip, Tear-Off, Peel-Off, or
Cut Media Handling option is enabled. The allowable range is –0.50
inches to the current Label Length value setting up to a maximum
of 12.80 inches in 0.01 inch increments.
The default is 0.00 inches.
Label Length
In most applications, the user-selected Label Length will match the
physical label length. Physical label length is the actual label length
of the media installed. Following is a list of different media types:
• Die-cut labels: measurable length of the removable label
(leading edge to trailing edge). This does not include the
liner material or gap.
• Tag stock with notches or holes: measurable length from
the trailing edge of one notch or hole to the trailing edge of
the next notch or hole.
• Tag stock with black marks on the underside: measurable
length from the leading edge of one black mark to the
leading edge of the next black mark.