User's Manual

Positioning The Media Sensors
39
QUICK SETUP Menu
QUICK SETUP
Print Intensity
6 ips* 2 to 10 ips
1
Print Speed
Print Mode
Paper Feed Shift
Label Width
Label Length
Orientation
Transfer* Direct
4.1, 6.6, or 8.5 inches*
2, 4
Portrait* Landscape Inv. Portrait Inv. Landscape
–3* –15 to 15
00.1 to 8.5 inches
4
0.00 inches*
2
4 or 6 inches*
2, 4
00.1 to 99.0 inches
5
–0.50 to X inches
3
Run Calibrate
Auto Calibrate
Ver Image Shift
Hor Image Shift
0.00 inches*
2
–1.00 to 1.00 inches 0.00 inches*
2
–1.00 to X inches
3
Tear-Off Strip* Tear-Off Peel-Off Cut
Media Handling
Continuous
Gap/Mark Sensor
Disable* Mark Gap Advanced NotchAdvanced Gap
Notes:
* = Default
1
Maximum value depends on the width of the
printer model and printhead.
2
You can change the unit value from inches to
millimeters under Units (in MEDIA CONTROL)
Refer to the
User’s Manual for information.
3
Based on the current value setting for the Label
Length menu, up to a maximum of 12.80 inches.
4
Maximum value depends on the width of the
printer model.
5
Maximum value depends on model width and size
of DRAM installed.
(cont. on next page)
1* 1 to 8
Factory* 1 to 8
Save Config.
Power-Up Config.