User's Manual

Adjusting The Voltage

Figure 6. Adjusting the Voltage

The facing arrows indicate the selected voltage setting. (Figure 6.). If the

setting is incorrect, adjust the voltage as follows:

1. Set the power switch to O (Off).

2. Insert the tip of a flat tip screwdriver into the slot above the fuse holder

assembly, and twist to remove the assembly.

3. Flip over the fuse holder assembly and make sure the fuse is in the active

fuse location.

NOTE: Refer to “Electrical” on page 250 for fuse electrical specifications.

4. Reinsert the fuse holder assembly. Make sure the facing arrows are

aligned properly.

Facing

Arrows

Selected

Voltage

Power

Switch

AC Power

Receptacle

Fuse Holder

Assembly

Active Fuse

Slot