User's Manual
Table Of Contents
- Unpacking And Installing The Printer
- Controls And Indicators
- Loading Media And Ribbon
- Printing Adjustments
- Calibrating The Printer
- Changing The Active IGP Emulation
- Configuring The Printer
- QUICK SETUP Menu
- Saving The Configuration
- Selecting The Power-Up Configuration
- Loading A Saved Configuration
- Run A Barcode Demo Test
- Cleaning
- Repacking The Printer
- For More Information
Making A Media Profile Printout
39
NOTE: Many QUICK SETUP menu items are available in other
main menus. (Refer to the
User’s Manual
.)
Changes made in the QUICK SETUP menu are updated in
the other main menus, and vice versa.
1* 1 to 8
Factory* 1 to 8
Save Config.
Power-Up Config.
IGP/PGL* PPI/ZGL
2
Active IGP Emul
PPI/TGL
2
PPI/IGL
2
IGP/VGL
QUICK SETUP
(cont. from previous page)
SMT: Status
3
Toolset [1]* Toolset [1] to Toolset [4]
SMT: Sel Toolset
3
Disabled* Enabled
EPC
4
zEPC
5, 6
SMT: Select Tool
3
Notes:
* = Default.
1
Appears only if a bar code validator is installed.
2
Appears only if the correct security key for the
PPI emulation is installed.
3
Appears only if an RFID encoder is installed.
4
Appears only if Toolset [1] is selected under
SMT: Sel Toolset.
5
Appears only if Toolset [2] is selected under
SMT: Sel Toolset.
6
Undocumented options are reserved for internal
use and future design.
UPCA
4
zUPCA
5, 6
EAN8
4
zEAN8
5, 6
EAN13
4
zEAN13
5, 6
UCC128
4
zUCC128
5, 6
GTIN
4
zGTIN
5, 6
PPI/STGL
2
Validator Funct.
1
Enable* Disable