The Micro 3D Printer User Manual
Welcome to 3D Printing! Thank you for purchasing The Micro 3D Printer, the first truly consumer 3D printer. The Micro is ready right out of the box to make your custom creations come to life. Just plug in the printer, download the models, hit print, and watch as you bring an object into the world through 3D printing. Let’s see what you print! Specifications Lower Build Volume: 110 mm x 107 mm x 73.
1.0 Unboxing The Micro 1. Lift The Micro from its packaging box. Remove all bubble wrap, foam, and tape (may require scissors). 2. Inside The Micro is an accessories box with a USB A-B cable and your country specific power supply. Be sure to remove the “Gantry Clips” located on the front left and front right corners of the printer.
2.0 Downloading M3D Software 1. Please visit http://www.PrintM3D.com/downloads to download your Operating System specific M3D Software. Download the M3D Software to a known location, like your Desktop. Run the installer and continue through all windows and prompts. 2. Run the M3D Software after it has fully installed. Your computer is now ready to automatically detect any M3D printers that are connected. 3. Please allow your printer to update to the most recent firmware.
4.0 Installing 3D Ink™ (Filament) Filament Installation is accessed by selecting the 3D Ink button in the top left corner of the M3D Software. You will be guided to install filament Externally or Internally . DO NOT attempt to load both ports at the same time during printing. Internal Filament *NOTE Factory Filament * There may be factory filament installed externally, let the printer extrude this first and then insert your filament of choice.
5.0 The First Print! 1. Quick Calibrate 2. Load the First Model Often a successful first print layer leads to a successful print! To be sure your printer is ready for its first print, select the Gear Icon to open the printer settings. Then go to the Calibration section where you can select Advanced Calibration . Now select the Recalibrate Bed Location button. This will begin the Quick Calibration process, which should take no more than 5 minutes.
6.0 Troubleshooting In the event of printer issues, visit the M3D support page online at http://www.PrintM3D.com/support . Search our technical articles, videos, and documentation for troubleshooting solutions or contact customer support. For additional language support please visit http://www.PrintM3D.com/support to find documentation in your language. 7.
Safety SAFETY AND WARNINGS: CHOKING HAZARD - The Micro 3D Printer and its consumables may include small parts that may constitute a choking hazard; additionally, these products may be used to manufacture objects that may themselves constitute a choking hazard. The Micro 3D Printer is NOT A TOY; children under the age of 14 should use the product under adult supervision. CAUTION! The printhead, exposed nozzle, extruded plastic, and areas near the nozzle may be extremely hot.
Legal Conditions M3D END USER AGREEMENT: This agreement between M3D LLC (a company incorporated under the laws of the State of Maryland in the United States), and you, the END-USER, which describes important disclaimers, indemnity, safety instructions, software information, and limited warranty information about its products and govern the conditions of use. PLEASE READ THESE TERMS CAREFULLY as continuing this installation process and using M3D products and software indicates agreement with these terms.
