Operator`s manual

PRINTER CONFIGURATION

FormsMaster 8000 Series Programmer’s Manual). When set to

Loopback, the interface will perform internal diagnostics and print the

result.

Reserved Parameter

(new)Parameter19

(unused)0

Possible Values: (unused)0*, 1 - 255

This item is reserved for future use.

Coax/Twinax Interface Items

When Configured for Twinax Operation

INTERFACE MENU

Twinax

When the optional Coax/Twinax Interface is installed, the printer will

automatically determine which of these two interfaces are being used by

sensing which adapter cable is attached to the printer at power on. If the

Twinax Smart-T adapter is attached, the following Setup items will be

displayed. If you are using the printer in a Coax Configuration, refer to the

previous section of this chapter.

Note: The Twinax Address is selected by using the rotary switch on the

back of the printer next to the 15 pin “D” connector where the twinax

Smart-T adapter is connected.

Printer Emulation

PrinterEmulation

4214