Operator`s manual

PRINTER CONFIGURATION

the left end of the line, use the left button. To use what is on the right end

of the line, use the right buttons. Note also that the menu system works on

a “what you see is what you get” basis. This means that whatever value is

last displayed for an item is the value that will be saved when Setup mode is

exited.

Entering Setup

To enter Setup, simply take the printer off line and press the SETUP button.

The ONLINE indicator will begin to flash yellow and the display will

temporarily show the following.

Entering

Setup Menus

After the above message has been shown, the display will change to the

first menu available, which is the

FORMS MENU as shown below. In this

case the display will also show the first submenu which will be the form

that was selected when Setup was pressed.

FORMS MENU

Form 0

Using the MENU Button

At this time you may select a different menu by pressing the MENU button

(closest to where

FORMS MENU is displayed). Other menus available are the

INTERFACE MENU, the OPTIONS MENU, and the TEST MENU. This button

will also display an option for exiting Setup. If you do not wish to exit

Setup at this time, press the button indicated for

No and continue to press

the MENU button to select the desired menu. The MENU button may be

pressed at any time to select a different menu.

Using the SUBMENU Button

The SUBMENU button selects additional menus that are related to the

selected menu. For instance, if the

FORMS MENU has been selected, the