Operator`s manual

DAILY OPERATION
25
SELECTING AND LOADING FORMS
Note: A form is not considered “loaded” by merely placing the
form in the tractors. To prevent printing on the wrong form,
the printer must be made aware of what form(s) are
currently loaded. When a new form is placed in the tractors,
the form must be “loaded” using the control panel as
described in the next section, “Loading a Different Form in
the Tractors”.
Selecting a Form Already Loaded in the Tractors
To select a form that is already loaded in the tractors, take the printer off
line and press the FORM SELECT button until that form is displayed (a form
that is not considered to be loaded will flash
<Not Loaded> on the bottom
line of the display). The form selection will be displayed as
FORM 0
through
FORM 9 or as the actual name of the form if that has been set up.
To position the form for printing, you may press the FORM FEED button
which will position the form, or you may press the ONLINE button which
will both position the form and place the printer on line.
Loading a New or Different Form In the Tractors
This section describes how to “load” a form in the tractors. This involves
physically placing the paper or form in the tractor mechanism and then
informing the printer that the new form is present.
Select the Form to be Loaded
1. Take the printer off line by pressing the ONLINE button. The
ONLINE indicator should now be flashing red.
2. Press the FORM SELECT/UNLOAD button. This will move the current
form from the print position down to the tractors for removal. In the