Operator`s manual

DAILY OPERATION
23
(display shows
<Not Loaded>), this
button will change the status of this form
to “loaded” and the bottom line of the
display will show the path(s).
FORM FEED:
• If a form is currently loaded and perhaps
partially printed, this button will advance
the bottom of the current form to the tear
bar so that it may be torn off.
• If a form has already been advanced to the
tear bar, this button will advance the next
form to the tear bar.
FORM SELECT
/UNLOAD
This button is used to access up to ten
different forms which have been previously
configured with the Setup menus (see the
chapter on Printer Configuration for more
information).
When this button is pressed, one of two
functions will be performed.
UNLOAD:
• If a form is currently in position to be
printed, this button will pull the form
down until the top of the form is below
the top of the tractors. In the
FormsMaster 8003 this will also cause the
tractor shuttle to move forward for easy
access to all tractors.
FORM SELECT:
• If the form has already been pulled down
to the tractors as described above, this
button will cycle through all the available
form choices. Forms which are not
considered to be “loaded” in the tractors
will flash
<not loaded> on the bottom