Instruction Manual

16
AFTER SALES SUPPORT AU 1300 777 137 NZ 0800 824 556 [e-mail]
Remote Control
Open the battery cover located on the back of the remote control. Check the
inside of the remote control battery chamber for the polarity symbols, then insert
2 x AAA batteries (not included). Replace the battery cover.
Fig. 6 Fig.7
Power ON/OFF
Press ‘ON/OFF’ button to switch the heater ON. Press again to switch the Outdoor
Heater OFF.
The
symbol indicates the signal strength between the remote control and the
Outdoor Heater. The more bars showing, the stronger the signal.
Clock Button
Use this button to set the time. Once remote is powered on, the time defaults to
00:00 (i.e. 12 AM, See Fig. 8.1).
Press the ‘Clock’ button and the hour digits will flash. Press
or arrow button to
reach desired hour (See Fig. 8.2).
Press the ‘Clock’ button again and the hour is set causing the minute digits to flash.
Press
or arrow button to reach desired minutes (See Fig. 8.3).
Press the ‘Clock’ button again and the minutes are set causing the second digits to
flash. Press or arrow button to reach desired seconds (See Fig. 8.4).
Operating Instructions (cont)