800W Infrared Outdoor Radiant Heater IA4547 INSTRUCTION MANUAL Please read and save all instructions to ensure safe and effective use of this Appliance
Table of Contents Important Safety and General Instructions 03 Parts List Diagram 06 Before First Use 08 Assembly 11 Location of Electrical Connection 14 Operating Instructions 15 Frequently Asked Questions 19 Cleaning, Care and Maintenance 20 Storage 21 Warranty Information 22 02 AFTER SALES SUPPORT AU 1300 777 137 NZ 0800 824 556 service@unclebills.com.
Important Safety and General Instructions Read this manual thoroughly before first use, even if you are familiar with this type of appliance. The safety precautions enclosed herein reduce the risk of fire, electric shock and injury when correctly adhered to. Please keep this user manual in a safe place along with your purchase receipt and carton for future reference. If applicable, pass these instructions and packaging on to the next owner of the appliance.
Important Safety and General Instructions (cont) 15. DO NOT put the cord on top of or wrap it around the Outdoor Heater. 16. DO NOT leave the Outdoor Heater unattended when plugged in. Always switch off and unplug the Outdoor Heater when not in use. To disconnect from the power supply, grip the plug and pull from the power socket. Never pull by the cord. The power plug must be removed from the power socket before cleaning, servicing, maintenance or moving the Outdoor Heater. 17.
Important Safety and General Instructions (cont) 30. To prevent damage to the appliance do not use alkaline cleaning agents or metal scouring pads. When cleaning the exterior, use a soft, damp cloth and a small amount of mild detergent. CAUTION: Never leave this Outdoor Heater unattended while it is switched on. This is very dangerous. CAUTION: Never hang clothing or manchester over the Outdoor Heater as it may cause a fire.
Parts List Diagram 2 3 4 1 5 7 6 Front of Unit Back of Unit 1. Front Radiating Surface 5. Heater Body 2. Infrared Receiver Module 6. Power Cord and Plug 3. LED Indicator Lights 7. Sliding Rails for Mounting Bracket 4. Manual Control Button 06 AFTER SALES SUPPORT AU 1300 777 137 NZ 0800 824 556 service@unclebills.com.
Parts List Diagram (cont) Remote Control 1. Display 2. Power Button 3. Timer On Button 4. Down Button 5. 1 2 3 Up Button 6. Timer Off Button 7. Fast Hot Button 8. Clock Button 5 4 6 8 7 Mounting Kit 1. Sliding Brackets x 2pcs 2. Fixed Mounting Brackets x 2pcs 3.
Before First Use Remove all the parts from the packaging materials and thoroughly read the user manual before using this appliance for the first time. Ensure all parts indicated on the parts diagram listed have been included in the gift box. Plastic wrapping can be a suffocation hazard for babies and young children so ensure all packaging materials are kept out of reach of children. • We recommend you keep the original packaging for storing the Outdoor Heater when not in use.
Before First Use (cont) Mounting Guide This Outdoor Heater comes with a pair of metal adjustable angle mounting brackets. The adjustable angle enables the heater to be installed on vertical, horizontal, and inclined surfaces. The ideal mounting position is directly above the area to be heated with a longitudinal orientation and facing vertically downwards. If this is not possible, the Outdoor Heater can be mounted on a wall and angled downwards. Please ensure the mounting height is within 2.1m to 3m.
Before First Use (cont) Clearance Guide Minimum clearances when mounting the Outdoor Heater on a vertical wall. Minimum clearances when mounting the Outdoor Heater parallel with a ceiling. Minimum clearances when mounting the Outdoor Heater at an angle to a ceiling. 10 AFTER SALES SUPPORT AU 1300 777 137 NZ 0800 824 556 service@unclebills.com.
Assembly Unpack the Outdoor Heater making sure that all the parts are present and that the heater is free from any packing material. Do not connect the heater to the power supply until all the assembly is complete. However, the Outdoor Heater needs to be installed within reach of a power supply. Be sure the cord length is within reach of the power supply before installing. Please read all instructions before installing the Outdoor Heater.
Assembly (cont) 3. Install the adjustable angle mounting brackets onto the nominated surface (wall or ceiling) using appropriate fixing screws suitable for the mounted surface material and able to support more than double the weight of the heater being installed (weight of heater = 6.8kg). For your convenience, expansion screws have been provided (see fig. 3).
Assembly (cont) For ceiling mounted installations, the mount angles should be restricted to anywhere in between 0° and 30° only. For wall mounted installations, the mount angles should be restricted to anywhere in between 15° and 45° only. 5. The Outdoor Heater is provided with a power cord fitted with 3 pin plug. Insert the corded plug into a power outlet and turn the power outlet On.
Location of Electrical Connection Electrical connections or GPOs MUST NOT be located at the back of the Outdoor Heater. They MUST be located outside the installation footprint of the units to reduce the effect of damage caused by heat build-up behind the Outdoor Heater. When mounted on an incline ensure the electrical connection is located at the lowest point of the Outdoor Heater.
Operating Instructions The Outdoor Heater can be operated manually or using a remote control (included). Manual Mode The Outdoor Heater has a Manual Control Button on the side of the Infrared Receiver Module (See Parts List Diagram on page 6 and Fig. 5 below). Fig. 5 When you press the Manual Control Button for the first time, the Outdoor Heater will switch ON. The Outdoor Heater will switch ON at the power (Heating) level at which it was last switched OFF.
Operating Instructions (cont) Remote Control Open the battery cover located on the back of the remote control. Check the inside of the remote control battery chamber for the polarity symbols, then insert 2 x AAA batteries (not included). Replace the battery cover. Fig. 6 Fig.7 Power ON/OFF Press ‘ON/OFF’ button to switch the heater ON. Press again to switch the Outdoor Heater OFF. The symbol indicates the signal strength between the remote control and the Outdoor Heater.
Operating Instructions (cont) Press the ‘Clock’ button again and the second digits will stop flashing and the time is now set. Fig. 8.1 Fig. 8.2 Fig. 8.3 Fig. 8.4 Heat Button Press the Heat Button to adjust the heat level when the Outdoor Heater is ON. The symbol indicates that the Outdoor Heater is ON. The symbol indicates the heating level the Outdoor Heater is operating at. Each bar indicates a different heating level. Refer to Fig. 9. 1 bar: 25% 2 bars: 50% 3 bars: 75% 4 bars: 100% Fig.
Operating Instructions (cont) Press the ‘Timer ON’ button again and the minutes are now set (See Fig. 11.4). Fig. 11.1 Fig. 11.2 Fig. 11.3 Fig. 11.4 The ON timer is now set and when the time reaches the time that has been set on the timer, the heater will then switch on. When the ON timer is set, the first LED light in the infrared receiver module will start flashing green. Once the timer is triggered the LED light will illuminate to solid red.
Frequently Asked Questions Problem Solution The Outdoor Heater does not switch on? Check main switch for the power outlet is turned ON. Check if remote control has batteries or if the batteries are still working. Check if you can switch ON the Outdoor Heater using the Manual Control Button. If the Outdoor Heater still will not switch ON, contact the After Sales Support on 1300 777 137 for advice.
Cleaning, Care and Maintenance CAUTION: Always switch off and disconnect the appliance from the power supply before attempting any maintenance or cleaning of the Outdoor Heater. Ensure the Outdoor Heater has cooled down completely. CAUTION: Never immerse the Outdoor Heater in water. 1. To clean the Outdoor Heater, use a soft, damp cloth. Never clean the unit with powerful or alkaline solutions such as benzene, thinner or polishing powder etc. 2.
Storage Before packing the Outdoor Heater away for storage, ensure it has completely cooled down and is clean and dry. • We recommend storing the Outdoor Heater in its original carton, which will protect it from dust. • Store the Outdoor Heater in a clean and dry place, out of children’s reach. • Do not place heavy objects on top during storage. AFTER SALES SUPPORT AU 1300 777 137 NZ 0800 824 556 service@unclebills.com.
Warranty Information Congratulations on your purchase This Prinetti® Outdoor Heater is warranted to be free from defects in material and workmanship under normal use and service conditions for a period of 12 months from the date of purchase of this article. Evidence of unfair usage or incorrect adjustment by the owner will void this promise. Defects that occur within this warranty period, under normal use and care, will be repaired, replaced or refunded at our discretion.
Warranty Information The service centre representative will assess the claim. If: 1. There is a minor fault, they can offer either a replacement spare part, replacement unit, repair or other suitable remedy. 2. There is a major fault, they can offer a replacement, repair or suggest you return to the store you purchased it from for a full refund. NOTE: A request for compensation will need documentary evidence of the loss or damage suffered.
