INDUSTRIAL TUMBLE DRYERS 11kg 13kg 13/13kg 15kg OPERATION / MAINTENANCE MANUAL 70269601R1 Publication date: Oct 2002
Installation must conform with local codes or in the absence of local codes with: In the U.S.A., installation must conform to the latest edition of the American National Standard Z223.1/ NFPA 54 “National Fuel Gas Code” and Standard ANSI/NFPA 70 “National Electric Code.” In Canada, installation must comply with Standards CSA-B149.1 or Natural Gas and Propane Code CSA C22.1, latest edition, Canadian Electric Code, Part I.
Notes 2 70269601
Table of Contents Introduction......................................................................................... Model Identification ............................................................................. Wiring Diagram .................................................................................... Serial Plate Location............................................................................. 5 5 5 6 Safety Information.................................................................
Notes 4 70269601
Introduction Model Identification Information in this manual is applicable to these models.
Introduction Serial Plate Location When calling or writing for information about your product, be sure to mention model and serial numbers. Model and serial numbers are found on serial plate on rear of machine, and/or inside door hinge. Refer to Figure 1. ANS 72152 CLOTHES DRYER.
Safety Information Precautionary statements (“DANGER,” “WARNING,” and “CAUTION”), followed by specific instructions, are found in this manual and on machine decals. These precautions are intended for the personal safety of the operator, user, servicer, and those maintaining the machine. DANGER DANGER indicates the presence of a hazard that will cause severe personal injury, death, or substantial property damage if the danger is ignored.
Safety Information Save These Instructions Important Safety Instructions 14. The interior of the tumbler and the exhaust duct should be cleaned periodically by qualified service personnel. WARNING To reduce the risk of fire, electric shock, serious injury or death to persons when using your tumbler, read and follow these basic precautions: W359 1. Read all instructions before using the tumbler. 2. Refer to the GROUNDING INSTRUCTIONS in the Installation Manual for the proper grounding of the tumbler. 3.
Safety Information 23. Remove laundry immediately after tumbler stops. 24. Always read and follow manufacturer’s instructions on packages of laundry and cleaning aids. Heed all warnings or precautions. To reduce the risk of poisoning or chemical burns, keep them out of reach of children at all times (preferably in a locked cabinet). 25. Do not tumble fiberglass curtains and draperies unless the label says it can be done.
Notes 10 70269601
Operating Instructions WARNING To reduce the risk of fire: • DO NOT DRY articles containing foam rubber or similarly textured rubberlike materials. • DO NOT DRY plastics, anything containing wax or chemicals such as mops and cleaning cloths, or anything dry-cleaned at home with a dry-cleaning solvent. • DO NOT TUMBLE fiberglass curtains and draperies unless the label says it can be done. If they are dried, wipe out the cylinder with a damp cloth to remove particles of fiberglass.
Operating Instructions 1 2 0 60 10 0 15 50 20 40 5 HEAT 10 30 HIGH 4 PUSH TO START COOL DOWN LOW 3 TMB47N Figure 3 Manual Timer 1. Set the HEAT (Drying) timer for the number of minutes (from 0-60) desired. 2. Set the COOL DOWN (Cooling) timer for the number of minutes (from 0-15) desired. 3. Set the Temperature selector at HIGH, LOW or anywhere between these settings. IMPORTANT: If the door is opened during the cycle, the heating system will shut off and the motor will stop.
Operating Instructions STATUS ON / SELECT HIGH START PROGRAM AUTO DRYING TIME AUTO MEDIUM MED LOW TEMP DISPLAY LOW SIGNAL SPECIAL CYCLE COOL DOWN STOP/RESET * DOOR OPEN AUTO TEMP SPECIAL TIME * COOL DOWN F/ C CUSTOM NO HEAT MORE + LESS CONDITION SAVE CUSTOM -- PROG TMB1789N TMB1789N Figure 4 Electronic OPL Control 2. Press START pad to start tumbler. 1. To use an Automatic Cycle, press an ON/ SELECT pad.
Operating Instructions 1 HIGH 2 SELECT TEMP TEMPERATURE 3 INSERT COIN PUSH START LOW INSERT QUARTER TURN KNOB QU PUSH TO START 25 ARTE RMAST ER TMB807N Figure 6 Electromechanical Coin Control 1. Set the TEMPERATURE selector at HIGH or LOW, or anywhere between these settings. 2. Coin Drop Models: Insert the coin(s) in the coin slot, turn the knob to the right and release it. 3. Press the PUSH TO START button and hold it for approximately three (3) seconds.
Operating Instructions 1 2 SELECT TEMP 3 INSERT COIN PUSH START 25 C HIGH TEMP MED TEMP START LOW TEMP NO HEAT T361I T361I Figure 7 Electronic Coin Control 1. Select HIGH TEMP, MED TEMP, LOW TEMP or NO HEAT by pressing the appropriate temperature pad. 2. Insert the coin(s) in the coin slot. IMPORTANT: To stop the tumbler at any time during the cycle, OPEN DOOR. To restart the tumbler, CLOSE door and press START pad. 4. When the cycle is complete, open door and remove the laundry. 3.
Operating Instructions C851I C851I Figure 8 NetMaster Coin Control 1. Select HIGH TEMP, MED TEMP, LOW TEMP or NO HEAT by pressing the appropriate temperature pad. 2. Insert the coin(s) in the coin slot. IMPORTANT: To stop the tumbler at any time during the cycle, OPEN DOOR. To restart the tumbler, CLOSE door and press START pad. 4. When the cycle is complete, open door and remove the laundry. 3. Press START pad to start tumbler.
Operating Instructions C852I C852I Figure 9 NetMaster Card Control 1. Select HIGH TEMP, MED TEMP, LOW TEMP or NO HEAT by pressing the appropriate temperature pad. 2. Insert card into opening. DO NOT remove the card until “REMOVE CARD” LED is lit. IMPORTANT: To stop the tumbler at any time during the cycle, OPEN DOOR. To restart the tumbler, CLOSE door and press START pad. 4. When the cycle is complete, open door and remove the laundry. 3. Press START pad to start tumbler.
Operating Instructions SELECT TEMP INSERT COINS or INSERT CARD PUSH START 25 C DRYING COOL DOWN DELICATES START TMB1964N Figure 10 MDC Coin Control 1. Select HIGH TEMP, MED TEMP, LOW TEMP or DELICATES by pressing the appropriate temperature pad. 2. Insert the coin(s) in the coin slot. IMPORTANT: To stop the tumbler at any time during the cycle, OPEN DOOR. To restart the tumbler, CLOSE door and press START pad. 4. When the cycle is complete, open door and remove the laundry. 3.
Operating Instructions SELECT TEMP DRYING PUSH START COOL DOWN INSERT CARD HERE DELICATES START TMB1965N Figure 11 MDC Card Control 1. Select HIGH TEMP, MED TEMP, LOW TEMP or DELICATES by pressing the appropriate temperature pad. 2. Insert card into opening. IMPORTANT: To stop the tumbler at any time during the cycle, OPEN DOOR. To restart the tumbler, CLOSE door and press START pad. 4. When the cycle is complete, open door and remove the laundry. 3. Press START pad to start tumbler.
Notes 20 70269601
Maintenance WARNING To reduce the risk of electric shock, fire, explosion, serious injury or death: • Disconnect electric power to the tumbler before servicing. • Close gas shut-off valve to gas tumbler before servicing. • Close steam valve to steam tumbler before servicing. • Never start the tumbler with any guards/panels removed. • Whenever ground wires are removed during servicing, these ground wires must be reconnected to ensure that the tumbler is properly grounded.
Maintenance WARNING To reduce the risk of electric shock, fire, explosion, serious injury or death: • Disconnect electric power to the tumbler before servicing. • Close gas shut-off valve to gas tumbler before servicing. • Close steam valve to steam tumbler before servicing. • Never start the tumbler with any guards/panels removed. • Whenever ground wires are removed during servicing, these ground wires must be reconnected to ensure that the tumbler is properly grounded.
Maintenance WARNING To reduce the risk of electric shock, fire, explosion, serious injury or death: • Disconnect electric power to the tumbler before servicing. • Close gas shut-off valve to gas tumbler before servicing. • Close steam valve to steam tumbler before servicing. • Never start the tumbler with any guards/panels removed. • Whenever ground wires are removed during servicing, these ground wires must be reconnected to ensure that the tumbler is properly grounded.
Maintenance WARNING To reduce the risk of electric shock, fire, explosion, serious injury or death: • Disconnect electric power to the tumbler before servicing. • Close gas shut-off valve to gas tumbler before servicing. • Close steam valve to steam tumbler before servicing. • Never start the tumbler with any guards/panels removed. • Whenever ground wires are removed during servicing, these ground wires must be reconnected to ensure that the tumbler is properly grounded.
Before You Call for Service Won’t Start Won’t Heat Clothes Not Dry Possible Reason – Corrective Actions • Insert correct coin(s) or valid card if applicable. • Close the loading door tightly. • Close lint panel tightly. • Press the PUSH TO START button. • Be sure power cord is plugged all the way into the electrical outlet. • Drying timer is in OFF position. • Check the main fuse and circuit breaker. • Check fuses located in the machine. 70269601 • Insufficient airflow.