Specifications

2 PROGRAMMING MANUAL 516307 C PUBLICATION DATE 31 JAN 2008.DOC
2. WARNINGS AND SYMBOLS
2.1. WARNINGS
BEFORE OPERATING A MACHINE CONTROLLED BY AN ELECTRONIC PROGRAMMER, READ THIS
MANUAL. INCORRECT USE CAN RESULT IN SERIOUS INJURIES OR DAMAGE TO THE MACHINE
CONTROLS. IGNORING INSTRUCTIONS CAN CAUSE AN INCORRECT MACHINE
FUNCTION, WHICH MAY RESULT IN INJURIES OR MACHINE AND/OR LINEN DAMAGES.
- This manual version is an original English version. Without the original version these instructions are not
complete. Before installation, operating and maintenance of the machine, read complete instructions
thoroughly. It means the following manuals: „Programming Manual“, „User‘s Manual“, „Installation
and Maintenance Manual“. Follow these instructions and keep them handy for later use.
- A machine must be installed according to „Installation and maintenance manual“. Before the first machine
starts, it must be initialized and tested by a qualified worker. When operating the machine, follow the machine
„User´s manual“.
- The electric service line must not be affected by other electrical loading. A nominal voltage, if loaded or not
must work in the range ±10% with a maximum permanent frequency deviation of 1% or a short-time one at
2% of a given frequency (50 or 60 Hz). Connecting or starting the machine at an incorrect voltage can damage
the programmer.
- The machine must not be exposed to high humidity
or extreme high and low temperatures.
- Do not tamper with the controls.
INSTRUCTIONS IN THIS MANUAL DO NOT COVER ALL DANGEROUS SITUATIONS.
IT IS UP TO THE USER TO HANDLE THE MACHINE CAREFULLY.
The manufacturer has the right to change specifications in this manual without prior notice. All the stated
information is only for informative purpose and must be considered as general. It is not possible to present
all the specific data of the device.
DANGER !!!
OPERATIONS THAT REQUIRE THE MACHINE TO BE OPENED MUST BE CARRIED OUT BY QUALIFIED
PERSONNEL WHO TAKE ALL THE NECESSARY MEASURES TO ENSURE EVERYBODY’S SAFETY.
AT THE END OF THESE OPERATIONS, THE MACHINE MUST BE RESTORED TO ITS ORIGINAL STATE.
NOTE !!!
EVERY CIRCUIT BOARD HAS A SERIAL NUMBER AND THE CODE NUMBER OF THE BOARD (SEE
FIGURE).
ON THE EPROM-FLASH MEMORY CHIP ON THE CIRCUIT BOARD IS STUCK A LABEL SPECIFYING
THE SOFTWARE NUMBER AND VERSION AND/OR THE DATE OF THE SOFTWARE (SEE FIGURE) .
THESE DATA, AS WELL AS THE MODEL AND SERIAL NUMBER OF THE MACHINE, MUST BE MENTIONED
IN ALL CORRESPONDENCE OR INQUIRIES ADDRESSED TO THE DEALER OR MANUFACTURER.
NOTE !!!
„THE EASY CONTROL“ COMPUTER IS USED IN COIN AND OPL MACHINES.
„THE EASY CONTROL“ COMPUTER USES „MACHINE TYPE“ CODES TO SELECT THE DIFFERENT
PROGRAMMABLE MACHINE EXECUTIONS.
The model number of the machine doesn’t indicate the ‚machine type‘ but must be linked with the
description of the ‚machine type‘ characters.
 Tx : Singel Dryer
 Tx, x : Double Dryer
!