Specifications

28 PROGRAMMING MANUAL 516307 C PUBLICATION DATE 31 JAN 2008.DOC
5. OPERATION MENU
5.1. STARTING UP
– Before starting up the first time: be sure that the machine is well installed, see installation manual
of machine.
– Be sure that the correct settings are made: see initialisation and configuration menu.
Ask the help of a technician.
– Make sure that the key switch is in the Run mode. Dryer programs can not be started if the key
switch is still in the Program mode.
5.2. SWITCHING ON THE POWER
The display lights up when you switch on the power.
5.3. LOAD THE DRYER
Open the door and load the laundry into the drum. When the drum is loaded, close the door.
5.4. SELECTING A DRYER PROGRAM
OPL version:
• Check the maximum temperature of the laundry that is put in the dryer.
• Press the desired temperature button.
• The preprogrammed time value is displayed.
• You can increase the drying time by pressing the same temperature button again.
COIN version:
• Press the desired temperature button.
• Insert a coin. The corresponding pre-programmed time value is displayed. Insert coins until
the required dry time is reached.
5.5. STARTING A DRYER PROGRAM
OPL version:
• Press the „START“ button, when the „START“-button LED is flashing.
COIN version:
• Insert the correct amount of coins. Press the „START“ button, when the „START“-button
LED is flashing.
External payement unit :
• Insert the correct amount of coins at the external payment unit. The start button light will
start flashing at the dryer keypad to indicate that you have to press the start button of the
dryer.
Now the dryer program is started and the complete drying process will be fulfilled.
5.6. ADVANCING THE DRYER PROGRAM
RUN MODE:
– OPL version:
• the advance function for the „START“ button must be set = ON (in the „t“-menu) to
activate the advance Function
– COIN version:
• no advance function
PROGRAM MODE:
• the advance function for the „START“ button is immediately activated when the
keyswitch is set in Program mode.
• Press the „START“ button to advance the program (it is only possible to advance
a program that has been started).