Specifications

8 PROGRAMMING MANUAL 516307 C PUBLICATION DATE 31 JAN 2008.DOC
 HOW TO MAKE A CORRECTION
After you have modified a menu-item, the display unit will stop flashing by pressing the „UPPER
TEMPERATURE“ button.
If you see that you have made a mistake, you can modify the menu-item once more by pressing the
„UPPER TEMPERATURE“ button. The display will start flashing again.
 WRITING THE MODIFICATIONS INTO THE MEMORY
When the updated values and settings are written into the EEPROM memory: dashes are displayed. This
occurs automatically when you leave the Submenu.
 RETURNING TO THE MAIN MENU
If you have finished the last step of the submenu, press the „MIDDLE TEMPERATURE“ button and you will
get back in the main menu. Now you can select another initialisation submenu or you can leave the
initialisation menu by the „o“ submenu.
„P“- PROGRAM SUBMENU
The PROGRAM Sub-Menu contains the dryer program settings.
In the -p- menu you can set the drying temperature, drying time, cooldown time, cooldown ratio.
In the menu’s:
• Program 1 corresponds with the Hight Temperature Program Button
• Program 2 corresponds with the Medium Temperature Program Button
• Program 3 corresponds with the Low Temperature Program Button
 DRYING CONTROL FUNCTION
Drying Temperature
The Desired Drying Temperature at the drying process.
d°1 : drying temperature program 1
d°2 : drying temperature program 2
d°3 : drying temperature program 3
The temperature can be set between 1 – 70°C.
T24 & T35 ELECTRICAL HEATING ONLY: 1 - 90°C
T24 & T35, GAS HEATING ONLY: 1 - 82°C
Defaults : d°1 = 70°C
d°2 = 55°C
d°3 = 40°C