Installation Manual

ECO 101-2546 07/20/2011 3-CMLT-1032 REV C
Secure the roof seal with at least six equally spaced roofing screws or pan head wood
screws and washers through the flange of the seal into the roof.
Wiring and Final Assembly
If the top of the pole cannot be reached from the roof of the structure the pole may be slid
down to a more accessible height by loosening the mount clamps and rotating the mast
while pushing down. Refer to your turbine owner’s manual to mount the turbine and wire it
to your electrical system properly.
If the turbine is to be mounted to a house or occupied structure where sound suppression
must be maximized, it is recommended that the wires be isolated from the inside of the
pole. This can be accomplished by installing water pipe insulation around the wires as they
are inserted into the pole. Doing this will prevent the turbine wires from rattling against the
inside of the pole.
If the pole was lowered to get the turbine onto it, lift and twist the pole until it is at the
desired height, then retighten the clamps.
End View of
Pole with
Wires and Pipe
Insulation
ECO 101-2546 07/20/2011 3-CMLT-1032 REV C
Parts List
Your Roof Mount Kit includes: Quantity
Isolators 4
Base Plates 2
Clamp Inserts 2
Clamp Straps 2
5/16” x 1” Bolts 4
5/16” Lock Washers 4
5/16” Nuts 4
Optional Roof Seal 1
Please inspect the contents to see that all parts are present and to familiarize yourself with
the pieces before beginning assembly.
Optional Roof Seal