Wind Control Panel

Wind Control Panel (WCP-D)
Primus Wind Power is pleased to offer a digital wind control panel for use with all AIR Wind Turbines (see chart
below). The panel is easy to install and will result in a professional operator station enhancing the beauty and value
of the Hybrid system installation. WCP-D includes a full indoor only, black plastic enclosure. Dimensions are: L - 6.5
inch / W - 4.25 inch / D - 2.5 inches. The WCP - D helps to reduce installation costs and makes wiring a snap with
just 4 wires to connect. The panel is available in 5 models specific to the AIR Wind Turbine – voltage and type.
P/N BREAKER SIZE TURBINE TYPE___________________________________________
2-ARAC-D-5 5 A AIR 40/BREEZE – 48 V
2-ARAC-D-10 10 A AIR 40/BREEZE – 24 V
2-ARAC-D-20 20 A AIR 30/AIR X MARINE/SILENT X – 48 V
AIR 40/AIR BREEZE – 12 V
2-ARAC-D-25 25 A AIR 30/AIR X MARINE/SILENT X – 24 V
2-ARAC-D-40 40 A AIR 30/AIR X MARINE/SILENT X – 12 V
MSRP - $309
The WCP-D controls and monitors the wind turbine. It is equipped with a power On/Off
circuit breaker, digital meter and a Stop/Run switch (for direct control of the turbine).
The digital meter (equipped with a 50 amp shunt) provides critical operational
information; real time battery voltage, current in amps, power in Watts and accumulated
energy in W/hours (re-settable). A clearly marked rear terminal block, The WCP terminal
blocks, which will accept an 8 AWG or smaller wire size, provides for easy interconnect of
the two turbine wires and two battery power wires. If a larger gauge wire is required, use
a few inches of 8 AWG wire to transition to the terminal blocks. Panel is fully factory
calibrated and ready for installation.
WIND
CONTROL
PANEL
BATTERY
BANK
WIND CONTROL PANEL DIAGRAM