Product Manual B

3
CONTACT US
Technical questions and support available: Primus Wind Power: Tech Support - 303-242-5820 ext. 3 / Email - [e-mail]
Back Side Of E-10 Enclosure Box
1"
Between Bushing
Holes
¾” Between
Bushing Hole
& Side of Box
¾” Between
Bushing Hole
& Side of Box
Cable Bushing
Width ¾”
Cable Bushing
Width ¾”
Make holes as close to back side as possible
Recommend placing Holes on either Top or Bottom Ends of Enclosure
4) Mount the now predrilled enclosure base into place. Insert wire bushings and pre-stripped wires
accordingly.
5) Make the connections as described in the section below, being sure that wires are routed internally
in the box to avoid interference with the internal components. The WCP terminal blocks, which
will accept an 8 AWG or smaller wire size, provides for easy interconnect of the two turbine wires
and two battery power wires.
6) Insert cover onto enclosure (it should easily fit in place, be cautious that the wires are not
interfering with the internal components or the cover) and secure with 4 original mounting screws
after wiring is complete.
ELECTRICAL INSTALLATION:
Wind Generator Connection: Mechanically tie off the wind turbine blade so that it cannot operate while making
your connections. Connect the wires of the 12-48V wind turbine feed wires to the terminals marked wind.
Negative to -2 and Positive to 1+ of the Control Panel using the appropriate wire size (8 AWG or smaller) which
the blocks will accept, see Figure 2. If a larger gauge wire is required, use a few inches of 8 AWG wire to
transition to the terminal blocks. The green grounding wire of the wind generator is connected to the grounding
system.
Warning
ABYC STANDARDS AND PRACTICES should be followed during the installation along with the
manufacturer’s recommendation. This manual is made available to assist during installation and start up
and is not intended to supersede the ABYC Standards or the Manufacturers requirements and
recommendations.