User manual

again. If you have chosen a delayed start,
the machine will begin the countdown.
If an incorrect option is selected, the red pi-
lot light of the button 4 blinks 3 times and
the message Err is displayed for a few sec-
onds.
Interrupting a programme
Press the button 4 to interrupt a pro-
gramme which is running, the correspond-
ing green pilot light starts blinking.
Press the button again to restart the pro-
gramme.
Cancelling a programme
Turn the selector dial to
to cancel a pro-
gramme which is running. Now you can se-
lect a new programme.
Opening the door
After the programme has started (or during
the delay time) the door is locked, if you
need to open it, set first the machine to
PAUSE by pressing the button 4. After a
few minutes it will be possible to open the
door.
If the door remains locked, this means that
the machine is already heating or that the
water level is too high. In any case, do not
force the door!
If you cannot open the door but you need
to open it you have to switch the machine
off by turning the selector dial to O. After a
few minutes the door can be opened (pay
attention to the water level and temper-
ature!).
After closing the door, it is necessary to se-
lect the programme and options again and
to press button 4.
At the end of the programme
The machine stops automatically. The pilot
light of button 4 and the pilot lights corre-
sponding to the finished phases go out.
The End pilot light illuminates to indicate
that the cycle is finished. In a few minutes it
will be possible to open the door.
If a programme or an option that ends with
water left in the tub has been selected, the
door remains locked. The water must be
emptied out before opening the door.
Follow the below instructions to empty out
the water:
1. Turn the programme selector dial to O.
2. Select the draining or spinning pro-
gramme.
3. Reduce the spin speed if needed, by
pressing the relevant button.
4. Press button 4.
At the end of the programme, the End pilot
light illuminates to indicate that the cycle is
finished. The door can be now opened.
Turn the programme selector dial to O to
switch the machine off.
Remove the laundry from the drum and
carefully check that the drum is empty. If
you do not intend to carry out another
wash, close the water tap. Leave the door
open to prevent the formation of mildew
and unpleasant smells.
Stand by : once the programme has finish-
ed after a few minutes the energy saving
system will be enabled. The brightness of
the display is reduced. By pressing any but-
ton the appliance will come out of the ener-
gy saving status.
8