Operating instructions

65
1. Install Batteries - Uses four (4) “D”
size Alkaline or Rechargeable batteries.
(Note: Camera identifies fully charged rechargeable
batteries, such as NiMH, as less than 99% on battery
indication level. Rechargeable batteries run on
different voltage and cause this variation. Most fully
charged rechargeable batteries will show 50-60%.)
2. Install up to 8GB SD Memory Card (not included) into the card slot
on the bottom of the camera. If SD Card is not installed, camera will display
“NO SD” on Initial Primos Menu Screen. (Note: SD Card Slot is protected by rubber
seal [plug]. Open door of the camera and gently rotate seal from slot. After SD Memory Card is
installed, replace rubber seal in original position to prevent moisture and elements from entering
camera and possibly causing malfunction.)
3. Secure Camera to Tree or Pole using included Mounting Strap
(must thread strap through Mounting Strap Slots on back of camera).
4. Turn On Camera and Slide Switches to desired settings. The LCD
screen will turn on and show the number of photos/videos on SD Card.
SD Card
QUICK START INITIAL CAMERA SETUP
Easy 6 Step Setup
5. Setup-Time and Date -Push UP or DOWN to find Time and Date
screens. While on respective screen, press Set button and then buttons
to adjust selected field.
6. Your camera is ready to use! After a 30 second delay the TRUTH
®
Camera will be armed and ready to take pictures whenever the Motion
Sensor detects motion or movement. (NOTE: TEST camera before placing in field/
woods. Run camera in live “On/Run” mode and make sure Photos/Videos are being saved on
SD Card. Can view number of Photos/Videos being saved from external window.)
Camera Settings Backup Battery
*** This TRUTH
®
Camera is equipped with an internal rechargeable backup
battery that is dedicated to saving the date, time and menu settings when the
main D-cell batteries are removed. This internal backup battery can preserve
your settings for up to 6 months when fully charged. (NOTE: With first use or after
a long period of time without camera use, internal battery may initially take up to 30 hours to fully
charge - charges only when “D” batteries are installed when camera is turned ON.)
RED LIGHT
(TIP: Walk in front of the camera and look for the red light to illuminate when you are detected.
You can do this to verify your camera is pointing in the correct direction. Remember there is a
30 second delay from the time the camera is turned on till it is ready to take pictures.)
GREEN LIGHT
Lights up when the camera takes photo or is recording a video. The green light
stays on while the photo/video is being stored on the SD Memory Card.
(NOTE: Do not remove SD Memory Card when the green light is blinking – this could cause you
to lose all data on memory card!)
(NOTE: The LCD screen will not wake up from ON/RUN mode [Power Saving State] while the
Green Status Light is on. Wait until after Green Light turns off to WAKE up LCD screen by pushing
any of the buttons.)
Your TRUTH
®
Camera is equipped
with 2 LED status indication lights
on the front of the camera (located
right above door opening on each
side of PIR Motion Sensor).
ON/OFF PROGRAM
SET
RUN/WAKE
Green Light
Red Light
Camera Status Lights
Lights up when the camera detects motion. After you close camera door
and are standing in front of the camera, visibility of this light is indication that
your camera is ON and working.