User's Guide

3 / 4
2.9 Screen will list out Sounds/Expert Hunts/Settings
2.10 Press "Arrow down" or "Arrow up" to "Settings" and press "Enter".
2.11 Screen will list out Source selection: SD/AUX/BT
2.12 Press "Arrow down" or "Arrow up" to the target source. The Speaker
will change the source automatic.
3 SD Play(Hunts Mode):
3.1 When select source on the Remote, press "Arrow down" or "Arrow
up" to "SD".
3.2 Press Menu Back to Main Menu.
3.3 Press "Arrow down" or "Arrow up" to "Sounds". And press "Enter".
3.4 Screen will list out Speaker selection.
3.5 Press "Arrow down" or "Arrow up" to target Speaker. And press
"Enter"
3.6 Screen will list out Sounds selection.
3.7 Press "Arrow down" or "Arrow up". Speaker will play the sounds
automatic when it's highlight.
4 AUX Play:
4.1 When select source on the Remote, press "Arrow down" or "Arrow
up" to "AUX".
4.2 Speaker can be play line in music per connect an Aux in cable.
5 BT Play:
5.1 When select source on the Remote, press "Arrow down" or "Arrow
up" to "BT".
5.2 Speaker can be connect with a BT player. And then can launch your
BT music.
6 TWS music:
6.1 Set one speaker in BT play mode.
6.2 Turn on another speaker.
6.3 The two speakers can be connect TWS automatic. And lunch BT
music.
6.4 Remind: Don't build speakers TWS group, before Mobile phone(BT
player) finish connect to speaker.
NOTE: This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.