Installation Sheet

3
INSTALLATION INSTRUCTIONS
FOR OUTDOOR ELECTRIC LANTERNS
ALL WALL MOUNTS
ONLY A QUALIFIED LICENSED ELECTRICIAN SHOULD
INSTALL THIS FIXTURE
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER
TOOLS AND MATERIALS REQUIRED
 ADJUSTABLE WRENCH
 WIRE CUTTERS
 FLAT BLADE SCREWDRIVER
 STEP LADDER
 WIRING SUPPLIES AS REQUIRED BY ELECTRICAL CODES
1. Shut of power at the fuse box or circuit breaker box and remove the old
fixture.
2. Carefully unpack your new fixture and lay out all the parts on a clear area.
Take care not to misplace any small parts necessary for installation
3. Pull black and white wires our of electrical outlet box
4. mount strap or cross bar to outlet box, by using the two screws supplied.
5. Make electrical connections: cut excess wire leaving six inches for electrical
connections. Fixture will have a black and white wire. Connect the white wire
to the white wire of supply circuit. Connect the black wire to the black wire of
the supply circuit. If your outlet has a ground wire (green or bare copper),
connect fixture ground wire to the green screw on the strap or cross bar. After
wires are connected, tuck them carefully inside junction box.
6. Screw the supplied nipple into the mounted strap and slide fixture onto the
nipple. Using the supplied nut, fasten the fixture on the nipple and screw
decorative finial to complete.
7. To prevent moisture from entering the outlet box and causing a short, use
clear caulking (i.e. indoor/outdoor silicone sealant) to outline the outside of
fixture back plate where it meets the wall and leave a space at bottom to allow
moisture a means to escape.
8. NOTE: install light bulbs in accordance with the fixture specification. DO
NOT EXCEED THE MAXIMUM WATTAGE RATING!
Your installation is now complete. Return power to the junction box and test
the fixture.