Quick Guide

iPRECIO
®
IMS-310R Quick guide ver.1.0.0 E
23
www.iprecio.com
4. Slide the south pole of a magnet (100mT or stronger) on the surface of the
protracted area of a pump to power on the pump.
Pump detection
1. Place pumps by recommended position with a data com unit UCD-X10R.
2. Click Detect button. During Communication progress bar is shown, the powered
on and communication enable pump will be detected. If a pimp is not detect wait
a minute or over, please try the power on action (power on by magnet).
If there is no response from pump, please check the followings:
It may take long term to detect pump due to radio wave back ground
Under red marked area,
magnet SW was built in.