Quick Guide

iPRECIO
®
IMS-310R Quick guide ver.1.0.0 E
11
www.iprecio.com
Cable connection of data communication unit UCD-X10R
1. Plug in the AC Adapter to data communication unit and connect with the PC which
the management software installed by cross-over type LAN cable.
*LAN cable Ferrite core attached end shall be connected to UCD-X10R.
*USB power Adapter cable Ferrite core attached end shall be connected to PC.
TCP/IP connection between data com unit and control PC
1. Connect data com unit and control PC with LAN cable
2. Open Network and Sharing Center from control panel.
3. Click Change adapter setting, then right click on the data com Local Area Control
and open Property.
4. Open Internet Protocol version 4(TCP/IPv4) property and input IP address below
IP Address: 192.168.1.11
Subnet mask: 255.255.255.0
Connect to LAN port of
Control PC
Plug in the USB Adapter to a PC
USB port (USB 2.0 or later)
Connect to LAN port of
UCD-X10R
Plug in the power plug to a
UCD
-
X10R power in port.