User`s manual

The LED Status Lights indicates that Power is ON and when
the Pause Button has been pressed. They also blink in certain
patterns to indicate an error or other condition of the
Duplicator. See Section 4 for a full explanation of the LED
Status Light conditions.
The Pause Button immediately pauses the motion of the
Robotic Arm. It is also used in combination with other buttons
to perform certain reset and error-clearing operations.
The Sequence Button moves the Robotic Arm from one
position to the next. It is used mainly during the set-up and
testing procedures. It is also used in combination with other
buttons to perform certain reset and error-clearing operations.
The Pick Button is used to manually pick up a disc and to
drop it in a Bin, the CD Recorder or the Reject area. It is also
used in combination with other buttons
The Input Bin is on the right side of the Duplicator. This is
where you stack up to 100 blank discs which are to be recorded
and printed.
The Output Bin is where discs are stacked, up to 100 at a time,
after they have been recorded and printed by the Duplicator.
The Reject Area is where discs are dropped if they do not pass
a software verification test. Discs simply drop on the table-top
in front of your Duplicator. In most cases, rejected discs should
be discarded.
For reference, the illustration below shows the optional
Thermal CD Printer attached to the Duplicator.
4 Getting Started
510231.qxd 10/2/03 9:14 AM Page 4
TOC
INDEX