User`s manual

Hardware and Software Set-Up and Testing 17
i. Open the printer tray with the disc in/out button. On the
Ink-Jet CD Printer, this is the button with the two arrows
pointing different directions. On the Thermal CD Printer,
this is the button on the lower right side of the front panel.
j. Press the Sequence button repeatedly until the Robotic
Arm comes to rest over the Printer's Disc Tray.
k. Press and hold the Pick button. After 5 seconds, the
Robotic Arm will lower the disc to the printer's tray. The
disc should align properly with the tray.
If it does not align properly, you will need to adjust the
printer stand's Mounting Plate. This is accomplished by
loosening the three Phillips-head adjusting screws and
moving the printer slightly in one direction or another
until the disc is dropped perfectly into the printer's tray.
You can repeatedly press the Pick button to test your
alignment. When the alignment is correct, tighten down
the screws securely.
510231.qxd 5/17/2004 8:45 AM Page 17
TOC
INDEX