User`s manual

Hardware and Software Set-Up and Testing 15
12. Apply power to the printer. One end of the Power Adapter
is connected to the printer's rear-panel Power Input Port.
The other end is attached to a wall outlet.
Note: The power supply for the inkjet printers is a 30 Volt supply. Both
the Thermal Printer and Duplicator require 24 Volt supplies. Please
be sure to connect the correct power supply to the correct device.
You have now completed the hardware and cabling set-up.
Continue on to the Hardware Test and Printer Alignment
procedures in the next section.
B. HARDWARE TEST AND PRINTER ALIGNMENT
1. Power-up your PC by re-connecting its main power cord.
Turn on the PC with its power button.
2. While waiting for Windows to start, perform a Hardware
Test as follows:
a. Place the gray plastic Input and Output Bins on top of
the duplicator.
510231.qxd 10/2/03 9:14 AM Page 15
TOC
INDEX