User`s manual

14 Hardware and Software Set-Up and Testing
9. Connect the other end of the 6-pin mini-DIN cable to the
Printer Control Port on the rear panel of the printer.
10. Connect the printer with an IEEE 1284 compliant parallel
cable. One end is connected to the parallel port on the rear
panel of the printer. The other end is connected to the
parallel port of your PC. Make sure that your PC's parallel
port is set to ECP mode. If you don't know how to check
this or how to change it, refer to set-up section of the
printer's Operator's Manual.
11. Make sure that all cables are routed neatly underneath and
out the back of the printer stand and that no cables are
underneath the Duplicator or printer stand feet.
510231.qxd 10/2/03 9:14 AM Page 14
TOC
INDEX