User`s manual

Hardware and Software Set-Up and Testing 11
4. Connect the Serial Interface cable. One end is connected to
the DB9 connector on the rear panel of the Duplicator. The
other end is connected to your PC's DB9 COM1 port. If
COM1 is already used for another device, you can use
COM2 or COM3 and follow on-screen instructions later in
the set-up procedure for changing the default serial port
for the Duplicator.
5. Apply power to the Duplicator. One end of the power
adapter's cord is attached to the power input port on the
rear panel of the Duplicator. The other end is connected to
a suitable wall outlet. Use of a high quality, commercially
available surge suppressor is highly recommended.
6. If you will be printing as well as duplicating discs, set-up
the printer according to its instructions and continue on to
step 7.
If you won't be attaching a printer, you have now completed
the Hardware and Cabling Set-Up procedure. Proceed to
Section B.
510231.qxd 5/17/2004 8:45 AM Page 11
TOC
INDEX