User`s manual

10 Hardware and Software Set-Up and Testing
Section 2: Hardware and Software
Set-Up and Testing
A. CONNECTING INTERFACE CABLES
1. Make sure that your PC is turned off and that it is
disconnected from its power source. Leave the PC turned
off until you are requested to turn it on later in this set-up
procedure.
2. Install a compatible FireWire board inside your PC. Please
refer to the board manufacturer’s instructions for the
proper installation procedure.
3. Connect the FireWire cable. One end is connected to the
FireWire port on the rear panel of the Duplicator. The
other end is connected to the FireWire board's output port
on your PC.
510231.qxd 5/17/2004 8:45 AM Page 10
TOC
INDEX