User guide

Manual (rev 16) for the DCMburner 4.x.x software Tuesday, July 16, 2013

Setup – Profiles – External Dicom Server

This section describes how to configure external Dicom server or Dicom SCP ( Service Class

providers). Normally the dicom studies are send by medical modalities, but you have also the

possibility to retrieve the studies from the existing dicom scp’s. In order to retrieve dicom studies you

have to configure the dicom servers or viewers (scp) with the dicom settings of DCMburner. You can

find these settings in the Setup - “Dicom Server” section. Which parameters are needed, Hostname or

the IP-address, Port Number and the AE-Title. Ones you configure your SCP’s you can add the

“External Dicom Server”.

Adding External Dicom Server

 To add an external Dicom Server press the “Add Dicom Server” button.

 Fill-in the server name, this is the AE-Title or an Alias.

 Add the AE-Title of the external dicom server.

 Add the IP-Address of the external dicom server.

 Add the Port of the external dicom server.

 Press the ping button to test the Dicom connection. If the Dicom ping fails you have to check

your dicom setting in the SCP.

Edit External Dicom Server

 Edit an existing external dicom server and test this with the dicom ping.

Delete External Dicom Server

 If an existing external dicom server isn’t needed any more then delete this.

Note: For testing, disable your firewall, if everything’s work well you can enable your Firewall again.

Make sure that you pass the port of the external dicom server and the port of then DCMburner.

Otherwise the Dicom ping and c-store is blocked.