User guide

Manual (rev 16) for the DCMburner 4.x.x software Tuesday, July 16, 2013
15
Setup – Publisher
 This section describes the Publisher setting, depending on which Publisher you use.
Setup – Publisher - “Epson”
This section describes the settings for the Epson Publishers.
 Publisher is already filled in. Otherwise the Job Folder is not correct.
 Job Folder, standard the location is “c:\EPSON\”. If this is not the case then change this
location by pressing the right button and choose the write folder.
 If you are planning to write standard more than one copy then select
how many copies you prefer.
 The Disc type can be set to CD, DVD or DVD-DL (Double Layer).
 The output Stacker is normally Stacker 4 for the Epson PP-100 or
Stacker 3 for the Epson PP-50.
 The standard format how a disc is written on the media is ISO9660L2.
This is the best setting, other Operating Systems like Linux or OSX
can read this disc format. Only if certain hardware has some problem reading the ISO format
you can change this in JOLIET, UDF102 or UDF102_BRIDGE.
o Specify "ISO9660L2" when creating the CD in ISO9660 Level 2 format.
o Specify "JOLIET" when creating the CD in Joliet format.
o Specify "UDF102" when creating the CD in UDF1.0.2 format.
o When not specified, the CD is burnt in ISO9660 Level 2 format.
o [When the disc type is DVD]
o Specify "UDF102" when creating the DVD in UDF1.0.2 format.
o Specify "UDF102_BRIDGE" when creating the DVD in UDF1.0.2 + UDF Bridge format.
o When not specified, the DVD is burnt in UDF1.0.2 + UDF Bridge format.
 To verify the Disc content select “YES” otherwise leave it.