User`s manual

Hardware and Software Set-Up 7
Section 2: Hardware and Software
Set-Up
This section will describe the step-by-step process of setting
up your OptiVault. This includes information on how to
load the supplies (ink and disc media) necessary to start
producing discs.
A. INSTALLING THE PC SOFTWARE
The Installer Disc has a menu that will guide you through the
process of setting up your OptiVault. Please refer to the
following for more information on each step:
1. Place the Installer CD in your CD-Rom Drive. The
Installer application should automatically launch in a few
moments. If it does, proceed to Step 2.
If it does not automatically launch, follow these steps:
• Double-click the My Computer Icon, then double-click
the icon of the appropriate CD drive containing the
Software Installer disc
• Double-click Installer.exe
2. In the Installer Application, click the Standard Install
button. The Standard Install will guide you step-by-step
through the installation process. As you complete each
step, click the → Next arrow. Steps 1-4 are shown in
section B below as well as on the monitor. You may follow
either to complete the setup.
B. HARDWARE SETUP
To connect your new Optivault, please do the following:
Be sure you have removed the packing tape and cardboard insert prior
to applying power.
Step 1: Applying Power
• Locate the power adapter
supplied with your Optivault.
• Place one end of the adapter
cord into the power port on the
rear panel of the Optivault.
• Unit will initialize for
approximately 30 seconds.
510934.qxd 10/28/2005 12:13 PM Page 7
INDEX
TOC