Setup guide

ElitePro Setup Guide
7
This brief setup guide is provided to get the autoloader operational out of the box. Once you
get the system operational, complete online help can be accessed from the DiscJuggler HELP
Section.
Step 1
Unpacking the Hardware:
Your system was shipped in 3 separate boxes. The larger box contains the autoloader unit,
keyboard, mouse and cables. The remaining two boxes contain the monitor and CD printer.
Carefully open the largest box and remove the top protective cardboard sheet. You will then be
able to remove the following:
CD Pick Arm
Keyboard
Mouse
Printer Control Cable
Printer USB Cable
AC Power Cord
Software and Manual
Set the components on a table that will hold the autoloader unit and your PC. Next, by lifting
straight up, carefully remove the foam container and foam protection over the autoloader unit.
You will see the autoloader in a plastic bag. The autoloader has lifting hand holders on either
side. Use these to remove the autoloader from the box. Remove the autoloader from its bag
and place all shipping components back into the shipping carton for future use. It is important
to always ship the duplicator in its proper container; so, storage of the box and accessories is
necessary. In the event you misplace your packaging and need to ship the duplicator, contact
the service department. A new shipping container will be shipped out.
Next, remove the monitor and the printer from their shipping carton. Place all the components
on the table.
Account for all the components and proceed to installation of the CD Pick Arm.
            
               
                  
                     
               
              